SuperheroDIY Nail Driver Guide | Hammer Your Nails In Straight!

This is a 3D-printed little helper I designed when building a kind of sewing frame. I needed to drive hundreds of nails as perpendicular as possible, leaving always the same length out, all by hand.

The part is 32 mm tall. It takes a wide range of nail sizes, speeding up work a lot while improving precision and perpendicularity. Should not be “whacked” directly! Hit the nail, not this driver (it will break, it’s plastic).

Just hold the nail in the V-slot with one or two fingers, put it on the wooden surface, hammer down until nail head touches the top of the driver (obviously you can also remove the driver and proceed to insert the nail further in the piece, if you need).

Printed in earth-friendly PLA plastic. Available in multiple colors.

Design credit to 3Dominion@Thingiverse:.thingiverse.com/thing:4829852