SuperheroDIY Headphone Stand For Jabra Evolve 75 Headset

This is a 3D-printed charging stand for Jabra Evolve 75 wireless headsets. You will need to supply a charging cable to use with this 3D-printed stand. You can also just use this as a stand without a charging cable attached if so desired.

**DOES NOT COME WITH CHARGING CABLE**

Materials needed:
– Anker Powerline Micro USB cable – A8133011 (Other cables probably will not fit): .amazon.com/Anker-Powerline-Micro-USB-Smartphones/dp/B012VZ7MUM
– Self-Stick Rubber Bumper Pads (ie: Scotch SP950-NA)

Install notes:
1. Route cable through channel first.
2. Some force is needed to insert the cable, you can use the tips of needle nose pliers to fully push it in.
3. Add rubber bumper pads to prevent the stand from sliding around on your desk.
4. Use caution when plugging in your headset in order not to damage its connector.

Measures 3.15 x 3.8 x 4.3″

Design credit to Tm@printables:.printables.com/model/99777-stand-for-jabra-evolve-75-headset

—————————————————————-
This is a 3D-printed, plastic item. Due to variables inherent in the printing process, it may have blemishes, layer lines, and other defects and/or minor sharp, small pieces of plastic which can be harmful if not handled properly. Sharp/rough edges can typically be smoothed with a heat gun or hair dryer, lightly softening the plastic then smoothing with a finger or other object.

That said, we work very hard to ensure that each item has a certain standard of quality. Please let us know if something is not up to snuff and we’ll do our best to fix it!

Materials: Earth friendly durable PLA plastic.