SuperheroDIY Flying-style Wall Mount For Hot Toys | Wall Mount For 1/6 Scale Sixth Scale Figure Display Rod

** DYNAMIC DISPLAY ROD NOT INCLUDED **

This is just the 3D-printed holder for the rod so you can mount it to the wall!

Have you ever wanted to display your 1/6 scale figures on the wall rather than in a DETOLF-style glass display case, table, counter, desk or other cabinet? Sometimes there just aren’t enough surfaces to display all these amazing sixth-scale figures and collectibles! That’s why we’ve created this collection of wall display shelves, which were all purposefully designed to meet this need.

This 3D-printed Flying Figure Wall Display Mount for Hot Toys 1/6 Scale Figure is meant to fit the dynamic display rod/wire/cable that comes with Hot Toys figures who have the power of flight! Do you have a Superman figure you don’t want to have attached to the base? How about Iron Man who should be taking flight? Get them mounted on the wall so they look like they’re flying, already!

This smart little part can be mounted to the wall with a screw (you should use a drywall anchor, not included), wherever you need it! Then, simply place the dynamic display rod/wire into the piece, and voila! Your figure is now displayed cleanly on the wall and appears to be mid-air, without a huge base underneath to ruin the effect.

While this mount is sturdy enough to hold Hot Toys and other collectible figures, props, or display items, it is a 3D-printed, plastic piece and can be broken. Please do not use for items weighing over 4 lbs.

Dimensions: 28.9 x 26.8 x 46.4 mm.

** FIGURE NOT INCLUDED **
** DYNAMIC DISPLAY ROD NOT INCLUDED **
** SCREWS NOT INCLUDED **

** NOT SUITABLE FOR HEAVIER FIGURES — NO upsized figures such as Venom, Thanos, Hulk, or die-cast figures – they WILL fall! **

—————————————————————

DISCLAIMER: This is a 3D-printed plastic item. As such, it may have blemishes and other defects and/or sharp, small pieces of plastic which can be harmful if not handled properly. Should not be used or handled by children without parent supervision.

This is a 3D-printed, plastic item. Due to variables inherent in the printing process, it may have blemishes, layer lines, and other defects and/or minor sharp, small pieces of plastic which can be harmful if not handled properly. Sharp/rough edges can typically be smoothed with a heat gun or hair dryer, lightly softening the plastic then smoothing with a finger or other object.

That said, we work very hard to ensure that each item has a certain standard of quality. Please let us know if something is not up to snuff and we’ll do our best to fix it!